A metal component can look flawless from the outside, but various defects can hide underneath. From small cracks to poor welding joints, all these things can affect performance and cost you a lot of money on repairs. This is why manufacturers and inspectors across the USA apply ultrasonic flaw detection equipment to inspect their materials non-destructively.
The digital ultrasonic flaw detector applies high-frequency sound waves for identifying internal defects which may go unnoticed by visual inspections. But each defect behaves differently during inspection.
Knowing about it can help you select appropriate inspection methods, improve your quality control system and prevent unexpected failures of the equipment.
1. Cracks in Welds and Metal Components
Cracks may form during welding, manufacturing or regular use of the equipment. They can appear along the welds, across the joints or below metal surfaces.
Fortunately, ultrasonic testing can help you find many internal cracks before they become major issues. But the sound beam must contact the crack at an appropriate angle.
That is why technicians usually apply angle-beam probes for inspecting welded joints.
2. Porosity and Trapped Gas Pockets
Porosity is a condition caused by gas being trapped in the molten metal during the solidification process. These pores may be present separately or clustered together, and even be elongated.
Ultrasonic flaw detection equipment can help to find many pores and clustered voids. But individual tiny pores can give you quite a weak signal.
In such cases, the inspector may use radiographic testing to complement UT.
3. Slag and Non-Metallic Inclusions
An inclusion is an unwanted material that gets trapped in a weld or metal component. The most common examples of such inclusions are slag and tungsten inclusions from specific welding processes.
Since these materials have different acoustic properties than the surrounding metal, they may reflect ultrasonic waves and give a signal.
But the technician should interpret them carefully because some signals may not represent real defects.
4.Lack of Fusion in Welded Joints
The lack of fusion defect appears when weld metal does not fuse with the base metal or with the previous welding layer.
Such a defect may appear along the weld sidewalls or between welding layers. In addition, this defect may decrease the joint strength.
Angle-beam UT helps to detect such flat internal boundaries. Thus, correct probe positioning is critical for reliable testing.
5.Incomplete Root Penetration
Incomplete penetration happens when weld metal does not reach the required depth at the joint root.
Thus, some part of the joint is not joined and may affect its strength.
UT may help you detect this defect through correct scanning technique. But joint geometry, material thickness and weld shape can complicate the interpretation of test results.
6. Laminations in Metal Plates
Laminations are flat separations that may be found inside rolled metal plates and other industrial components.
Such defects can influence the performance of materials, particularly around the welded areas.
The straight-beam ultrasonic probe will help to detect many layered discontinuities. This is why technicians may inspect metal plates for laminations before more detailed inspection of the welds.
7.Corrosion and Wall Thickness Loss
Corrosion leads to gradual reduction of the wall thickness of the pipe, tank or pressure equipment.
Fortunately, ultrasonic thickness testing measures the remaining wall thickness non-destructively.
This will help you to track material deterioration and assess the equipment condition for planning repairs. But accurate thickness measurements depend on correct calibration and surface preparation.
Why Ultrasonic Inspection Is Important?
The digital ultrasonic flaw detector helps technicians to inspect internal discontinuities and review test signals.
Advanced techniques such as PAUT and TOFD may help in more precise flaw evaluation.
Choose RTUL Group International for Ultrasonic Testing Solutions
RTUL Group International is an expert in designing, developing and manufacturing ultrasonic machines. The company’s expertise includes welding, cleaning, sieving, non-destructive testing, sonochemistry, fabric cutting and sealing, and specialised applications.
Looking for reliable ultrasonic flaw detection equipment? Contact RTUL Group International to find ultrasonic NDT solutions for industrial applications.